Recycled PETG Settings for Monoprice MP Voxel
Recommended slicer settings for printing Recycled PETG on the Monoprice MP Voxel (150 x 150 x 150 mm build volume, 100 mm/s max speed, direct drive extruder).
Uyumlu Değilbeginner
Uyumlu Değil
The max bed temperature of 60°C is below the recommended 75°C for Recycled PETG. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 225-250°C |
| Printer Max Nozzle | 260°C |
| Filament Bed Requirement | 75-90°C |
| Printer Max Bed | 60°C |
Bunun yerine yapılması gerekenler
- Your printer's bed maxes out at 60°C, but Recycled PETG needs at least 75°C for reliable adhesion.
- Try a compatible filament for your Monoprice MP Voxel — PLA, PETG, and ABS are good options.
- If you need Recycled PETG specifically, you'll need a printer with a hotend capable of 225°C+ nozzle.
Recycled PETG Requirements
Recycled PETG Properties
| Nozzle Range | 225-250°C |
| Bed Range | 75-90°C |
| Speed Range | 30-50 mm/s |
| Difficulty | beginner |
| Enclosure | Not needed |
| Drying | 65°C / 7h |
Monoprice MP Voxel Specs
| Build Volume | 150 x 150 x 150 mm |
| Max Speed | 100 mm/s |
| Max Nozzle Temp | 260°C |
| Max Bed Temp | 60°C |
| Extruder | Direct Drive |
Recycled PETG Bir Bakışta
Güçlü Yönleri
- Eco-friendly recycled material
- Similar properties to virgin PETG
- Good impact and chemical resistance
- Reduces plastic waste
Zayıf Yönleri
- Color consistency may vary
- Slightly more stringing than virgin PETG
- Limited color options
Kişiselleştirilmiş yapay zeka ayarları ister misin?
Tam kurulumunu ve ne yazdırdığını açıkla. 3DSearch'ün yapay zeka uzmanı saniyeler içinde Recycled PETG ile Monoprice MP Voxel için özel slicer ayarları oluşturuyor.
3DSearch'ü dene →Kaynaklar: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Değerler filament belirtimleri ve yazıcı donanım sınırlarından hesaplanmıştır.