Recycled PETG Settings for Monoprice MP Voxel
Recommended slicer settings for printing Recycled PETG on the Monoprice MP Voxel (150 x 150 x 150 mm build volume, 100 mm/s max speed, direct drive extruder).
Not Compatiblebeginner
Not Compatible
The max bed temperature of 60°C is below the recommended 75°C for Recycled PETG. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 225-250°C |
| Printer Max Nozzle | 260°C |
| Filament Bed Requirement | 75-90°C |
| Printer Max Bed | 60°C |
What to do instead
- Your printer's bed maxes out at 60°C, but Recycled PETG needs at least 75°C for reliable adhesion.
- Try a compatible filament for your Monoprice MP Voxel — PLA, PETG, and ABS are good options.
- If you need Recycled PETG specifically, you'll need a printer with a hotend capable of 225°C+ nozzle.
Recycled PETG Requirements
Recycled PETG Properties
| Nozzle Range | 225-250°C |
| Bed Range | 75-90°C |
| Speed Range | 30-50 mm/s |
| Difficulty | beginner |
| Enclosure | Not needed |
| Drying | 65°C / 7h |
Monoprice MP Voxel Specs
| Build Volume | 150 x 150 x 150 mm |
| Max Speed | 100 mm/s |
| Max Nozzle Temp | 260°C |
| Max Bed Temp | 60°C |
| Extruder | Direct Drive |
Recycled PETG at a Glance
Strengths
- Eco-friendly recycled material
- Similar properties to virgin PETG
- Good impact and chemical resistance
- Reduces plastic waste
Weaknesses
- Color consistency may vary
- Slightly more stringing than virgin PETG
- Limited color options
Want personalized AI settings?
Describe your exact setup and what you are printing. 3DSearch's AI expert generates custom slicer settings for your Monoprice MP Voxel with Recycled PETG in seconds.
Try 3DSearch →Sources: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Values calculated from filament specifications and printer hardware limits.