ABS Settings for Monoprice MP Voxel
Recommended slicer settings for printing ABS on the Monoprice MP Voxel (150 x 150 x 150 mm build volume, 100 mm/s max speed, direct drive extruder).
Niet compatibelintermediate
Niet compatibel
The max bed temperature of 60°C is below the recommended 95°C for ABS. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 230-260°C |
| Printer Max Nozzle | 260°C |
| Filament Bed Requirement | 95-110°C |
| Printer Max Bed | 60°C |
Wat je in plaats daarvan kunt doen
- Your printer's bed maxes out at 60°C, but ABS needs at least 95°C for reliable adhesion.
- Try a compatible filament for your Monoprice MP Voxel — PLA, PETG, and ABS are good options.
- If you need ABS specifically, you'll need a printer with a hotend capable of 230°C+ nozzle.
ABS Requirements
ABS Properties
| Nozzle Range | 230-260°C |
| Bed Range | 95-110°C |
| Speed Range | 30-70 mm/s |
| Difficulty | intermediate |
| Enclosure | Required |
| Drying | 77°C / 4h |
Monoprice MP Voxel Specs
| Build Volume | 150 x 150 x 150 mm |
| Max Speed | 100 mm/s |
| Max Nozzle Temp | 260°C |
| Max Bed Temp | 60°C |
| Extruder | Direct Drive |
ABS in één oogopslag
Sterke punten
- Good heat resistance (softens ~105C)
- Good impact resistance
- Can be acetone-smoothed for glossy finish
- Widely used classic engineering plastic
- Good for functional indoor parts
Zwakke punten
- Warps aggressively without enclosure
- Emits styrene fumes (ventilation needed)
- Poor UV resistance (yellows in sunlight)
- Requires high bed temperature
Wil je gepersonaliseerde AI-instellingen?
Beschrijf je exacte setup en wat je afdrukt. 3DSearch's AI-expert genereert in seconden aangepaste slicer-instellingen voor je Monoprice MP Voxel met ABS.
Probeer 3DSearch →Bronnen: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Waarden berekend op basis van filamentspecificaties en printerhard warelimiet.