Recycled PETG Settings for Monoprice MP Voxel
Recommended slicer settings for printing Recycled PETG on the Monoprice MP Voxel (150 x 150 x 150 mm build volume, 100 mm/s max speed, direct drive extruder).
Non compatiblebeginner
Non compatible
The max bed temperature of 60°C is below the recommended 75°C for Recycled PETG. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 225-250°C |
| Printer Max Nozzle | 260°C |
| Filament Bed Requirement | 75-90°C |
| Printer Max Bed | 60°C |
Que faire à la place
- Your printer's bed maxes out at 60°C, but Recycled PETG needs at least 75°C for reliable adhesion.
- Try a compatible filament for your Monoprice MP Voxel — PLA, PETG, and ABS are good options.
- If you need Recycled PETG specifically, you'll need a printer with a hotend capable of 225°C+ nozzle.
Recycled PETG Requirements
Recycled PETG Properties
| Nozzle Range | 225-250°C |
| Bed Range | 75-90°C |
| Speed Range | 30-50 mm/s |
| Difficulty | beginner |
| Enclosure | Not needed |
| Drying | 65°C / 7h |
Monoprice MP Voxel Specs
| Build Volume | 150 x 150 x 150 mm |
| Max Speed | 100 mm/s |
| Max Nozzle Temp | 260°C |
| Max Bed Temp | 60°C |
| Extruder | Direct Drive |
Recycled PETG en un coup d'œil
Points forts
- Eco-friendly recycled material
- Similar properties to virgin PETG
- Good impact and chemical resistance
- Reduces plastic waste
Points faibles
- Color consistency may vary
- Slightly more stringing than virgin PETG
- Limited color options
Tu veux des réglages IA personnalisés ?
Décris ton setup exact et ce que tu imprimes. L'expert IA de 3DSearch génère des réglages de slicer sur mesure pour ton Monoprice MP Voxel avec Recycled PETG en quelques secondes.
Essayer 3DSearch →Sources : Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Valeurs calculées à partir des spécifications du filament et des limites matérielles de l'imprimante.