Glass-fiber PETG Settings for Monoprice MP Voxel
Recommended slicer settings for printing Glass-fiber PETG on the Monoprice MP Voxel (150 x 150 x 150 mm build volume, 100 mm/s max speed, direct drive extruder).
No Compatibleintermediate
No Compatible
The max bed temperature of 60°C is below the recommended 80°C for Glass-fiber PETG. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 235-260°C |
| Printer Max Nozzle | 260°C |
| Filament Bed Requirement | 80-95°C |
| Printer Max Bed | 60°C |
Qué hacer en su lugar
- Your printer's bed maxes out at 60°C, but Glass-fiber PETG needs at least 80°C for reliable adhesion.
- Try a compatible filament for your Monoprice MP Voxel — PLA, PETG, and ABS are good options.
- If you need Glass-fiber PETG specifically, you'll need a printer with a hotend capable of 235°C+ nozzle.
Glass-fiber PETG Requirements
Glass-fiber PETG Properties
| Nozzle Range | 235-260°C |
| Bed Range | 80-95°C |
| Speed Range | 30-50 mm/s |
| Difficulty | intermediate |
| Enclosure | Not needed |
| Drying | 65°C / 7h |
Monoprice MP Voxel Specs
| Build Volume | 150 x 150 x 150 mm |
| Max Speed | 100 mm/s |
| Max Nozzle Temp | 260°C |
| Max Bed Temp | 60°C |
| Extruder | Direct Drive |
Glass-fiber PETG de un Vistazo
Fortalezas
- Much stiffer than standard PETG
- Better heat resistance than plain PETG
- Good dimensional stability
- Less expensive than carbon fiber composites
Debilidades
- Hardened steel nozzle required
- Increased brittleness vs standard PETG
- Use 0.5mm+ nozzle to prevent clogging
- Rougher surface finish
¿Quieres configuraciones de IA personalizadas?
Describe tu configuración exacta y qué estás imprimiendo. El experto en IA de 3DSearch genera configuraciones de slicer personalizadas para tu Monoprice MP Voxel con Glass-fiber PETG en segundos.
Prueba 3DSearch →Fuentes: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Valores calculados a partir de especificaciones de filamento y límites de hardware de impresora.