Glass-fiber PETG Settings for Monoprice MP Voxel
Recommended slicer settings for printing Glass-fiber PETG on the Monoprice MP Voxel (150 x 150 x 150 mm build volume, 100 mm/s max speed, direct drive extruder).
Nicht kompatibelintermediate
Nicht kompatibel
The max bed temperature of 60°C is below the recommended 80°C for Glass-fiber PETG. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 235-260°C |
| Printer Max Nozzle | 260°C |
| Filament Bed Requirement | 80-95°C |
| Printer Max Bed | 60°C |
Was du stattdessen tun kannst
- Your printer's bed maxes out at 60°C, but Glass-fiber PETG needs at least 80°C for reliable adhesion.
- Try a compatible filament for your Monoprice MP Voxel — PLA, PETG, and ABS are good options.
- If you need Glass-fiber PETG specifically, you'll need a printer with a hotend capable of 235°C+ nozzle.
Glass-fiber PETG Requirements
Glass-fiber PETG Properties
| Nozzle Range | 235-260°C |
| Bed Range | 80-95°C |
| Speed Range | 30-50 mm/s |
| Difficulty | intermediate |
| Enclosure | Not needed |
| Drying | 65°C / 7h |
Monoprice MP Voxel Specs
| Build Volume | 150 x 150 x 150 mm |
| Max Speed | 100 mm/s |
| Max Nozzle Temp | 260°C |
| Max Bed Temp | 60°C |
| Extruder | Direct Drive |
Glass-fiber PETG auf einen Blick
Stärken
- Much stiffer than standard PETG
- Better heat resistance than plain PETG
- Good dimensional stability
- Less expensive than carbon fiber composites
Schwächen
- Hardened steel nozzle required
- Increased brittleness vs standard PETG
- Use 0.5mm+ nozzle to prevent clogging
- Rougher surface finish
Möchtest du personalisierte KI-Einstellungen?
Beschreibe dein genaues Setup und was du druckst. 3DSearch's KI-Experte erzeugt in Sekunden individuelle Slicer-Einstellungen für deinen Monoprice MP Voxel mit Glass-fiber PETG.
3DSearch ausprobieren →Quellen: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Werte berechnet aus Filament-Spezifikationen und Drucker-Hardware-Limits.