Kevlar-fill Nylon Settings for Monoprice MP Voxel
Recommended slicer settings for printing Kevlar-fill Nylon on the Monoprice MP Voxel (150 x 150 x 150 mm build volume, 100 mm/s max speed, direct drive extruder).
不兼容advanced
不兼容
The max bed temperature of 60°C is below the recommended 85°C for Kevlar-fill Nylon. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 245-275°C |
| Printer Max Nozzle | 260°C |
| Filament Bed Requirement | 85-100°C |
| Printer Max Bed | 60°C |
该怎么办
- Your printer's bed maxes out at 60°C, but Kevlar-fill Nylon needs at least 85°C for reliable adhesion.
- Try a compatible filament for your Monoprice MP Voxel — PLA, PETG, and ABS are good options.
- If you need Kevlar-fill Nylon specifically, you'll need a printer with a hotend capable of 245°C+ nozzle.
Kevlar-fill Nylon Requirements
Kevlar-fill Nylon Properties
| Nozzle Range | 245-275°C |
| Bed Range | 85-100°C |
| Speed Range | 25-45 mm/s |
| Difficulty | advanced |
| Enclosure | Required |
| Drying | 85°C / 12h |
Monoprice MP Voxel Specs
| Build Volume | 150 x 150 x 150 mm |
| Max Speed | 100 mm/s |
| Max Nozzle Temp | 260°C |
| Max Bed Temp | 60°C |
| Extruder | Direct Drive |
Kevlar-fill Nylon 速览
优势
- Kevlar fibers add toughness without brittleness
- Better impact resistance than carbon fiber nylon
- Good abrasion resistance
- Lighter than carbon fiber composites
劣势
- Hardened nozzle required
- Very hygroscopic
- Expensive and limited availability
- Lower stiffness than carbon fiber variants
想要个性化的 AI 参数？
描述你的具体配置和要打印的内容。3DSearch 的 AI 专家会在几秒内为你的 Monoprice MP Voxel 搭配 Kevlar-fill Nylon 生成定制切片参数。
试用 3DSearch →来源： Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. 参数根据耗材规格和打印机硬件上限计算得出。