Nylon Settings for Markforged Mark Two
Recommended slicer settings for printing Nylon on the Markforged Mark Two (320 x 132 x 154 mm build volume, 200 mm/s max speed, direct drive extruder).
不兼容advanced
不兼容
The max bed temperature of 0°C is below the recommended 70°C for Nylon. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 240-280°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 70-90°C |
| Printer Max Bed | N/A |
该怎么办
- Your printer's bed maxes out at 0°C, but Nylon needs at least 70°C for reliable adhesion.
- Try a compatible filament for your Markforged Mark Two — PLA, PETG, and ABS are good options.
- If you need Nylon specifically, you'll need a printer with a hotend capable of 240°C+ nozzle.
Nylon Requirements
Nylon Properties
| Nozzle Range | 240-280°C |
| Bed Range | 70-90°C |
| Speed Range | 30-50 mm/s |
| Difficulty | advanced |
| Enclosure | Required |
| Drying | 80°C / 16h |
Markforged Mark Two Specs
| Build Volume | 320 x 132 x 154 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
Nylon 速览
优势
- Highest tensile strength among common filaments (50-90 MPa)
- Excellent wear and abrasion resistance
- Excellent fatigue resistance (living hinges, snap fits)
- Good heat resistance (PA6 softens ~180C)
- Ideal for gears, bearings, and mechanical parts
劣势
- Extremely hygroscopic (absorbs moisture rapidly)
- Requires extensive drying (12-20 hours)
- Must print from a dry box
- Warps aggressively without enclosure
- Difficult to get right for beginners
想要个性化的 AI 参数？
描述你的具体配置和要打印的内容。3DSearch 的 AI 专家会在几秒内为你的 Markforged Mark Two 搭配 Nylon 生成定制切片参数。
试用 3DSearch →来源： Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. 参数根据耗材规格和打印机硬件上限计算得出。