PEEK Settings for Markforged Mark Two
Recommended slicer settings for printing PEEK on the Markforged Mark Two (320 x 132 x 154 mm build volume, 200 mm/s max speed, direct drive extruder).
Not Compatible
The Markforged Mark Two has a max nozzle temperature of 300°C, which may be below the minimum recommended 370°C for PEEK. Printing may be possible at the lower end of the temperature range but results may be suboptimal. The max bed temperature of 0°C is below the recommended 130°C for PEEK. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 370-420°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 130-160°C |
| Printer Max Bed | N/A |
What to do instead
- Your printer's hotend maxes out at 300°C, but PEEK needs at least 370°C. No amount of tuning can overcome this hardware limitation.
- Your printer's bed maxes out at 0°C, but PEEK needs at least 130°C for reliable adhesion.
- Try a compatible filament for your Markforged Mark Two — PLA, PETG, and ABS are good options.
- If you need PEEK specifically, you'll need a printer with an all-metal hotend rated for 370°C+ nozzle and 130°C+ heated bed.
PEEK Requirements
PEEK Properties
| Nozzle Range | 370-420°C |
| Bed Range | 130-160°C |
| Speed Range | 15-30 mm/s |
| Difficulty | advanced |
| Enclosure | Required |
| Drying | 150°C / 6h |
Markforged Mark Two Specs
| Build Volume | 320 x 132 x 154 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
PEEK at a Glance
Strengths
- Heat resistance up to 250°C continuous
- Exceptional chemical resistance
- Aerospace and medical grade material
- Biocompatible grades available
Weaknesses
- Requires specialized printer (400°C+ hotend, heated enclosure)
- Extremely expensive (~$300-700/kg)
- Needs heated chamber at 120°C+
- Cannot be printed on consumer-grade machines
Want personalized AI settings?
Describe your exact setup and what you are printing. 3DSearch's AI expert generates custom slicer settings for your Markforged Mark Two with PEEK in seconds.
Try 3DSearch →Sources: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Values calculated from filament specifications and printer hardware limits.