TPU Settings for Markforged Mark Two
Recommended slicer settings for printing TPU on the Markforged Mark Two (320 x 132 x 154 mm build volume, 200 mm/s max speed, direct drive extruder).
Non compatibleintermediate
Non compatible
The max bed temperature of 0°C is below the recommended 40°C for TPU. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 210-240°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 40-60°C |
| Printer Max Bed | N/A |
Que faire à la place
- Your printer's bed maxes out at 0°C, but TPU needs at least 40°C for reliable adhesion.
- Try a compatible filament for your Markforged Mark Two — PLA, PETG, and ABS are good options.
- If you need TPU specifically, you'll need a printer with a hotend capable of 210°C+ nozzle.
TPU Requirements
TPU Properties
| Nozzle Range | 210-240°C |
| Bed Range | 40-60°C |
| Speed Range | 20-50 mm/s |
| Difficulty | intermediate |
| Enclosure | Not needed |
| Drying | 70°C / 7h |
Markforged Mark Two Specs
| Build Volume | 320 x 132 x 154 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
TPU en un coup d'œil
Points forts
- Flexible and rubber-like
- Excellent impact absorption
- Excellent abrasion resistance
- 300-600% elongation at break
- Great for phone cases, gaskets, wheels, dampeners
Points faibles
- Must print very slowly
- Difficult on Bowden extruders
- High moisture sensitivity
- Stringing is common
- Retraction must be minimized
Tu veux des réglages IA personnalisés ?
Décris ton setup exact et ce que tu imprimes. L'expert IA de 3DSearch génère des réglages de slicer sur mesure pour ton Markforged Mark Two avec TPU en quelques secondes.
Essayer 3DSearch →Sources : Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Valeurs calculées à partir des spécifications du filament et des limites matérielles de l'imprimante.