TPU 95A Settings for Markforged Mark Two
Recommended slicer settings for printing TPU 95A on the Markforged Mark Two (320 x 132 x 154 mm build volume, 200 mm/s max speed, direct drive extruder).
Not Compatibleintermediate
Not Compatible
The max bed temperature of 0°C is below the recommended 40°C for TPU 95A. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 210-235°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 40-60°C |
| Printer Max Bed | N/A |
What to do instead
- Your printer's bed maxes out at 0°C, but TPU 95A needs at least 40°C for reliable adhesion.
- Try a compatible filament for your Markforged Mark Two — PLA, PETG, and ABS are good options.
- If you need TPU 95A specifically, you'll need a printer with a hotend capable of 210°C+ nozzle.
TPU 95A Requirements
TPU 95A Properties
| Nozzle Range | 210-235°C |
| Bed Range | 40-60°C |
| Speed Range | 15-30 mm/s |
| Difficulty | intermediate |
| Enclosure | Not needed |
| Drying | 50°C / 5h |
Markforged Mark Two Specs
| Build Volume | 320 x 132 x 154 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
TPU 95A at a Glance
Strengths
- Standard flexible filament — Shore 95A hardness
- Good balance of flexibility and printability
- Excellent impact and abrasion resistance
- Stretches 300-500% before breaking
Weaknesses
- Must print slowly
- Difficult on Bowden extruders — direct drive preferred
- Minimal retraction needed (causes jams)
- Stringing is common
Want personalized AI settings?
Describe your exact setup and what you are printing. 3DSearch's AI expert generates custom slicer settings for your Markforged Mark Two with TPU 95A in seconds.
Try 3DSearch →Sources: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Values calculated from filament specifications and printer hardware limits.