CPE Settings for Markforged Mark Two
Recommended slicer settings for printing CPE on the Markforged Mark Two (320 x 132 x 154 mm build volume, 200 mm/s max speed, direct drive extruder).
Uyumlu Değilintermediate
Uyumlu Değil
The max bed temperature of 0°C is below the recommended 75°C for CPE. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 240-270°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 75-90°C |
| Printer Max Bed | N/A |
Bunun yerine yapılması gerekenler
- Your printer's bed maxes out at 0°C, but CPE needs at least 75°C for reliable adhesion.
- Try a compatible filament for your Markforged Mark Two — PLA, PETG, and ABS are good options.
- If you need CPE specifically, you'll need a printer with a hotend capable of 240°C+ nozzle.
CPE Requirements
CPE Properties
| Nozzle Range | 240-270°C |
| Bed Range | 75-90°C |
| Speed Range | 30-50 mm/s |
| Difficulty | intermediate |
| Enclosure | Not needed |
| Drying | 60°C / 6h |
Markforged Mark Two Specs
| Build Volume | 320 x 132 x 154 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
CPE Bir Bakışta
Güçlü Yönleri
- Excellent chemical resistance
- Higher heat resistance than PETG (~100°C)
- Good toughness and impact resistance
- FDA-compliant grades available
Zayıf Yönleri
- More difficult to print than PETG
- Higher temperatures required
- More prone to stringing
- Limited brand availability
Kişiselleştirilmiş yapay zeka ayarları ister misin?
Tam kurulumunu ve ne yazdırdığını açıkla. 3DSearch'ün yapay zeka uzmanı saniyeler içinde CPE ile Markforged Mark Two için özel slicer ayarları oluşturuyor.
3DSearch'ü dene →Kaynaklar: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Değerler filament belirtimleri ve yazıcı donanım sınırlarından hesaplanmıştır.