PA6-CF Settings for Monoprice MP Voxel
Recommended slicer settings for printing PA6-CF on the Monoprice MP Voxel (150 x 150 x 150 mm build volume, 100 mm/s max speed, direct drive extruder).
Niet compatibeladvanced
Niet compatibel
The max bed temperature of 60°C is below the recommended 85°C for PA6-CF. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 255-280°C |
| Printer Max Nozzle | 260°C |
| Filament Bed Requirement | 85-100°C |
| Printer Max Bed | 60°C |
Wat je in plaats daarvan kunt doen
- Your printer's bed maxes out at 60°C, but PA6-CF needs at least 85°C for reliable adhesion.
- Try a compatible filament for your Monoprice MP Voxel — PLA, PETG, and ABS are good options.
- If you need PA6-CF specifically, you'll need a printer with a hotend capable of 255°C+ nozzle.
PA6-CF Requirements
PA6-CF Properties
| Nozzle Range | 255-280°C |
| Bed Range | 85-100°C |
| Speed Range | 25-45 mm/s |
| Difficulty | advanced |
| Enclosure | Required |
| Drying | 85°C / 12h |
Monoprice MP Voxel Specs
| Build Volume | 150 x 150 x 150 mm |
| Max Speed | 100 mm/s |
| Max Nozzle Temp | 260°C |
| Max Bed Temp | 60°C |
| Extruder | Direct Drive |
PA6-CF in één oogopslag
Sterke punten
- Extremely stiff and strong
- Better dimensional stability than PA6
- Reduced moisture absorption vs plain PA6
- Professional matte finish
Zwakke punten
- Hardened steel nozzle mandatory
- Very hygroscopic — dry box printing essential
- Expensive (~$50-80/kg)
- Brittle compared to unreinforced PA6
Wil je gepersonaliseerde AI-instellingen?
Beschrijf je exacte setup en wat je afdrukt. 3DSearch's AI-expert genereert in seconden aangepaste slicer-instellingen voor je Monoprice MP Voxel met PA6-CF.
Probeer 3DSearch →Bronnen: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Waarden berekend op basis van filamentspecificaties en printerhard warelimiet.