ASA Settings for Markforged Mark Two
Recommended slicer settings for printing ASA on the Markforged Mark Two (320 x 132 x 154 mm build volume, 200 mm/s max speed, direct drive extruder).
Niet compatibelintermediate
Niet compatibel
The max bed temperature of 0°C is below the recommended 90°C for ASA. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 240-260°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 90-110°C |
| Printer Max Bed | N/A |
Wat je in plaats daarvan kunt doen
- Your printer's bed maxes out at 0°C, but ASA needs at least 90°C for reliable adhesion.
- Try a compatible filament for your Markforged Mark Two — PLA, PETG, and ABS are good options.
- If you need ASA specifically, you'll need a printer with a hotend capable of 240°C+ nozzle.
ASA Requirements
ASA Properties
| Nozzle Range | 240-260°C |
| Bed Range | 90-110°C |
| Speed Range | 40-60 mm/s |
| Difficulty | intermediate |
| Enclosure | Required |
| Drying | 77°C / 4h |
Markforged Mark Two Specs
| Build Volume | 320 x 132 x 154 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
ASA in één oogopslag
Sterke punten
- Best UV resistance of common filaments (10x better than ABS)
- Excellent for outdoor functional parts
- Does not yellow or become brittle in sunlight
- Good impact resistance (similar to ABS)
- Good heat resistance (softens ~100C)
Zwakke punten
- Requires enclosure (like ABS)
- Emits fumes (similar to ABS)
- More expensive than ABS
- Still prone to warping without enclosure
Wil je gepersonaliseerde AI-instellingen?
Beschrijf je exacte setup en wat je afdrukt. 3DSearch's AI-expert genereert in seconden aangepaste slicer-instellingen voor je Markforged Mark Two met ASA.
Probeer 3DSearch →Bronnen: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Waarden berekend op basis van filamentspecificaties en printerhard warelimiet.