POM Settings for Anycubic Kobra 2 Plus
Recommended slicer settings for printing POM on the Anycubic Kobra 2 Plus (320 x 320 x 400 mm build volume, 300 mm/s max speed, direct drive extruder).
Niet compatibeladvanced
Niet compatibel
The max bed temperature of 90°C is below the recommended 100°C for POM. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 200-220°C |
| Printer Max Nozzle | 260°C |
| Filament Bed Requirement | 100-130°C |
| Printer Max Bed | 90°C |
Wat je in plaats daarvan kunt doen
- Your printer's bed maxes out at 90°C, but POM needs at least 100°C for reliable adhesion.
- Try a compatible filament for your Anycubic Kobra 2 Plus — PLA, PETG, and ABS are good options.
- If you need POM specifically, you'll need a printer with a hotend capable of 200°C+ nozzle and 100°C+ heated bed.
POM Requirements
POM Properties
| Nozzle Range | 200-220°C |
| Bed Range | 100-130°C |
| Speed Range | 20-40 mm/s |
| Difficulty | advanced |
| Enclosure | Not needed |
| Drying | 60°C / 6h |
Anycubic Kobra 2 Plus Specs
| Build Volume | 320 x 320 x 400 mm |
| Max Speed | 300 mm/s |
| Max Nozzle Temp | 260°C |
| Max Bed Temp | 90°C |
| Extruder | Direct Drive |
POM in één oogopslag
Sterke punten
- Lowest friction of any printable plastic
- Replaces machined Delrin/Acetal parts
- Self-lubricating — ideal for gears and bearings
- Excellent fatigue resistance
Zwakke punten
- Extremely difficult bed adhesion
- Requires POM-specific build surface or tape
- Emits formaldehyde fumes — ventilation required
- Very few printers handle it well
Wil je gepersonaliseerde AI-instellingen?
Beschrijf je exacte setup en wat je afdrukt. 3DSearch's AI-expert genereert in seconden aangepaste slicer-instellingen voor je Anycubic Kobra 2 Plus met POM.
Probeer 3DSearch →Bronnen: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Waarden berekend op basis van filamentspecificaties en printerhard warelimiet.