PLA+ Settings for Markforged Mark Two
Recommended slicer settings for printing PLA+ on the Markforged Mark Two (320 x 132 x 154 mm build volume, 200 mm/s max speed, direct drive extruder).
互換性なしbeginner
互換性なし
The max bed temperature of 0°C is below the recommended 50°C for PLA+. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 200-230°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 50-70°C |
| Printer Max Bed | N/A |
代わりにすること
- Your printer's bed maxes out at 0°C, but PLA+ needs at least 50°C for reliable adhesion.
- Try a compatible filament for your Markforged Mark Two — PLA, PETG, and ABS are good options.
- If you need PLA+ specifically, you'll need a printer with a hotend capable of 200°C+ nozzle.
PLA+ Requirements
PLA+ Properties
| Nozzle Range | 200-230°C |
| Bed Range | 50-70°C |
| Speed Range | 40-60 mm/s |
| Difficulty | beginner |
| Enclosure | Not needed |
| Drying | Not required |
Markforged Mark Two Specs
| Build Volume | 320 x 132 x 154 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
PLA+一目でわかる
強み
- Up to 4x better impact resistance than PLA
- Higher heat tolerance (70-80C vs 55-60C for PLA)
- Better layer adhesion
- Less brittle than standard PLA
- Same ease of printing as PLA
弱点
- Not a standardized spec (varies by brand)
- Slightly more expensive than PLA
- Some brands offer little improvement over regular PLA
- Still not suitable for high-heat or heavy-load applications
パーソナライズされたAI設定が欲しいですか？
あなたの正確なセットアップと印刷内容を説明してください。3DSearchのAIエキスパートが数秒であなたのMarkforged Mark Two用のPLA+カスタムスライサー設定を生成します。
3DSearchを試す →ソース: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. フィラメント仕様とプリンターハードウェア制限から計算。