BVOH Settings for Markforged Mark Two
Recommended slicer settings for printing BVOH on the Markforged Mark Two (320 x 132 x 154 mm build volume, 200 mm/s max speed, direct drive extruder).
互換性なしbeginner
互換性なし
The max bed temperature of 0°C is below the recommended 50°C for BVOH. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 190-220°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 50-60°C |
| Printer Max Bed | N/A |
代わりにすること
- Your printer's bed maxes out at 0°C, but BVOH needs at least 50°C for reliable adhesion.
- Try a compatible filament for your Markforged Mark Two — PLA, PETG, and ABS are good options.
- If you need BVOH specifically, you'll need a printer with a hotend capable of 190°C+ nozzle.
BVOH Requirements
BVOH Properties
| Nozzle Range | 190-220°C |
| Bed Range | 50-60°C |
| Speed Range | 20-40 mm/s |
| Difficulty | beginner |
| Enclosure | Not needed |
| Drying | Not required |
Markforged Mark Two Specs
| Build Volume | 320 x 132 x 154 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
BVOH一目でわかる
強み
- Water-soluble support material
- Dissolves faster than PVA (2-4 hours)
- Works with wider range of build materials
- Leaves very clean supported surfaces
弱点
- Extremely moisture sensitive — use immediately after opening
- More expensive than PVA
- Must store in sealed dry container
- Limited shelf life once opened
パーソナライズされたAI設定が欲しいですか？
あなたの正確なセットアップと印刷内容を説明してください。3DSearchのAIエキスパートが数秒であなたのMarkforged Mark Two用のBVOHカスタムスライサー設定を生成します。
3DSearchを試す →ソース: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. フィラメント仕様とプリンターハードウェア制限から計算。