Kevlar-fill Nylon Settings for Monoprice MP Voxel
Recommended slicer settings for printing Kevlar-fill Nylon on the Monoprice MP Voxel (150 x 150 x 150 mm build volume, 100 mm/s max speed, direct drive extruder).
לא תואםadvanced
לא תואם
The max bed temperature of 60°C is below the recommended 85°C for Kevlar-fill Nylon. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 245-275°C |
| Printer Max Nozzle | 260°C |
| Filament Bed Requirement | 85-100°C |
| Printer Max Bed | 60°C |
מה לעשות במקום
- Your printer's bed maxes out at 60°C, but Kevlar-fill Nylon needs at least 85°C for reliable adhesion.
- Try a compatible filament for your Monoprice MP Voxel — PLA, PETG, and ABS are good options.
- If you need Kevlar-fill Nylon specifically, you'll need a printer with a hotend capable of 245°C+ nozzle.
Kevlar-fill Nylon Requirements
Kevlar-fill Nylon Properties
| Nozzle Range | 245-275°C |
| Bed Range | 85-100°C |
| Speed Range | 25-45 mm/s |
| Difficulty | advanced |
| Enclosure | Required |
| Drying | 85°C / 12h |
Monoprice MP Voxel Specs
| Build Volume | 150 x 150 x 150 mm |
| Max Speed | 100 mm/s |
| Max Nozzle Temp | 260°C |
| Max Bed Temp | 60°C |
| Extruder | Direct Drive |
Kevlar-fill Nylon במבט מהיר
יתרונות
- Kevlar fibers add toughness without brittleness
- Better impact resistance than carbon fiber nylon
- Good abrasion resistance
- Lighter than carbon fiber composites
חסרונות
- Hardened nozzle required
- Very hygroscopic
- Expensive and limited availability
- Lower stiffness than carbon fiber variants
רוצה הגדרות AI מותאמות אישית?
תאר את ההגדרה המדויקת שלך ואת מה שאתה מדפיס. מומחה ה-AI של 3DSearch מייצר הגדרות סלייסר מותאמות עבור ה-Monoprice MP Voxel שלך עם Kevlar-fill Nylon תוך שניות.
נסה את 3DSearch →מקורות: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. הערכים חושבו ממפרטי הפילמנט וממגבלות החומרה של המדפסת.