PETG Settings for Monoprice MP Voxel
Recommended slicer settings for printing PETG on the Monoprice MP Voxel (150 x 150 x 150 mm build volume, 100 mm/s max speed, direct drive extruder).
Non compatiblebeginner
Non compatible
The max bed temperature of 60°C is below the recommended 80°C for PETG. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 230-250°C |
| Printer Max Nozzle | 260°C |
| Filament Bed Requirement | 80-90°C |
| Printer Max Bed | 60°C |
Que faire à la place
- Your printer's bed maxes out at 60°C, but PETG needs at least 80°C for reliable adhesion.
- Try a compatible filament for your Monoprice MP Voxel — PLA, PETG, and ABS are good options.
- If you need PETG specifically, you'll need a printer with a hotend capable of 230°C+ nozzle.
PETG Requirements
PETG Properties
| Nozzle Range | 230-250°C |
| Bed Range | 80-90°C |
| Speed Range | 40-60 mm/s |
| Difficulty | beginner |
| Enclosure | Not needed |
| Drying | 65°C / 7h |
Monoprice MP Voxel Specs
| Build Volume | 150 x 150 x 150 mm |
| Max Speed | 100 mm/s |
| Max Nozzle Temp | 260°C |
| Max Bed Temp | 60°C |
| Extruder | Direct Drive |
PETG en un coup d'œil
Points forts
- Excellent all-around material for functional parts
- Good impact resistance (much better than PLA)
- Moderate heat resistance (softens ~80C)
- FDA-approved for food contact in raw form
- Good chemical resistance
- Semi-flexible (bends before breaking)
Points faibles
- Prone to stringing
- Moderate moisture sensitivity
- Can bond too strongly to glass beds
- Lower fan speeds required (not great for overhangs)
Tu veux des réglages IA personnalisés ?
Décris ton setup exact et ce que tu imprimes. L'expert IA de 3DSearch génère des réglages de slicer sur mesure pour ton Monoprice MP Voxel avec PETG en quelques secondes.
Essayer 3DSearch →Sources : Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Valeurs calculées à partir des spécifications du filament et des limites matérielles de l'imprimante.