Nylon Settings for Monoprice MP Voxel
Recommended slicer settings for printing Nylon on the Monoprice MP Voxel (150 x 150 x 150 mm build volume, 100 mm/s max speed, direct drive extruder).
Non compatibleadvanced
Non compatible
The max bed temperature of 60°C is below the recommended 70°C for Nylon. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 240-280°C |
| Printer Max Nozzle | 260°C |
| Filament Bed Requirement | 70-90°C |
| Printer Max Bed | 60°C |
Que faire à la place
- Your printer's bed maxes out at 60°C, but Nylon needs at least 70°C for reliable adhesion.
- Try a compatible filament for your Monoprice MP Voxel — PLA, PETG, and ABS are good options.
- If you need Nylon specifically, you'll need a printer with a hotend capable of 240°C+ nozzle.
Nylon Requirements
Nylon Properties
| Nozzle Range | 240-280°C |
| Bed Range | 70-90°C |
| Speed Range | 30-50 mm/s |
| Difficulty | advanced |
| Enclosure | Required |
| Drying | 80°C / 16h |
Monoprice MP Voxel Specs
| Build Volume | 150 x 150 x 150 mm |
| Max Speed | 100 mm/s |
| Max Nozzle Temp | 260°C |
| Max Bed Temp | 60°C |
| Extruder | Direct Drive |
Nylon en un coup d'œil
Points forts
- Highest tensile strength among common filaments (50-90 MPa)
- Excellent wear and abrasion resistance
- Excellent fatigue resistance (living hinges, snap fits)
- Good heat resistance (PA6 softens ~180C)
- Ideal for gears, bearings, and mechanical parts
Points faibles
- Extremely hygroscopic (absorbs moisture rapidly)
- Requires extensive drying (12-20 hours)
- Must print from a dry box
- Warps aggressively without enclosure
- Difficult to get right for beginners
Tu veux des réglages IA personnalisés ?
Décris ton setup exact et ce que tu imprimes. L'expert IA de 3DSearch génère des réglages de slicer sur mesure pour ton Monoprice MP Voxel avec Nylon en quelques secondes.
Essayer 3DSearch →Sources : Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Valeurs calculées à partir des spécifications du filament et des limites matérielles de l'imprimante.