PVA Settings for Markforged Mark Two
Recommended slicer settings for printing PVA on the Markforged Mark Two (320 x 132 x 154 mm build volume, 200 mm/s max speed, direct drive extruder).
No Compatibleintermediate
No Compatible
The max bed temperature of 0°C is below the recommended 50°C for PVA. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 185-215°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 50-60°C |
| Printer Max Bed | N/A |
Qué hacer en su lugar
- Your printer's bed maxes out at 0°C, but PVA needs at least 50°C for reliable adhesion.
- Try a compatible filament for your Markforged Mark Two — PLA, PETG, and ABS are good options.
- If you need PVA specifically, you'll need a printer with a hotend capable of 185°C+ nozzle.
PVA Requirements
PVA Properties
| Nozzle Range | 185-215°C |
| Bed Range | 50-60°C |
| Speed Range | 20-30 mm/s |
| Difficulty | intermediate |
| Enclosure | Not needed |
| Drying | 50°C / 5h |
Markforged Mark Two Specs
| Build Volume | 320 x 132 x 154 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
PVA de un Vistazo
Fortalezas
- Water-soluble support material
- Leaves near-perfect supported surfaces
- Dissolves in tap water (2-12 hours)
- Best paired with PLA
- No manual support removal needed
Debilidades
- Extremely moisture sensitive (dissolves in water)
- Expensive (~$40-60/kg)
- Requires dual-extruder setup
- Must be stored in airtight container at all times
- Brittle when moisture-damaged
¿Quieres configuraciones de IA personalizadas?
Describe tu configuración exacta y qué estás imprimiendo. El experto en IA de 3DSearch genera configuraciones de slicer personalizadas para tu Markforged Mark Two con PVA en segundos.
Prueba 3DSearch →Fuentes: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Valores calculados a partir de especificaciones de filamento y límites de hardware de impresora.