PHA Settings for Markforged Mark Two
Recommended slicer settings for printing PHA on the Markforged Mark Two (320 x 132 x 154 mm build volume, 200 mm/s max speed, direct drive extruder).
No Compatiblebeginner
No Compatible
The max bed temperature of 0°C is below the recommended 40°C for PHA. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 175-200°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 40-60°C |
| Printer Max Bed | N/A |
Qué hacer en su lugar
- Your printer's bed maxes out at 0°C, but PHA needs at least 40°C for reliable adhesion.
- Try a compatible filament for your Markforged Mark Two — PLA, PETG, and ABS are good options.
- If you need PHA specifically, you'll need a printer with a hotend capable of 175°C+ nozzle.
PHA Requirements
PHA Properties
| Nozzle Range | 175-200°C |
| Bed Range | 40-60°C |
| Speed Range | 25-45 mm/s |
| Difficulty | beginner |
| Enclosure | Not needed |
| Drying | Not required |
Markforged Mark Two Specs
| Build Volume | 320 x 132 x 154 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
PHA de un Vistazo
Fortalezas
- Fully biodegradable in soil and marine environments
- Renewable bioplastic from bacterial fermentation
- Non-toxic and biocompatible
- Easier to print than PLA in some cases
Debilidades
- Lower heat resistance than PLA (~55°C)
- More expensive than PLA
- Limited availability and color options
- Slower degradation rate than marketed
¿Quieres configuraciones de IA personalizadas?
Describe tu configuración exacta y qué estás imprimiendo. El experto en IA de 3DSearch genera configuraciones de slicer personalizadas para tu Markforged Mark Two con PHA en segundos.
Prueba 3DSearch →Fuentes: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Valores calculados a partir de especificaciones de filamento y límites de hardware de impresora.