Nylon Settings for Monoprice MP Voxel
Recommended slicer settings for printing Nylon on the Monoprice MP Voxel (150 x 150 x 150 mm build volume, 100 mm/s max speed, direct drive extruder).
Nicht kompatibeladvanced
Nicht kompatibel
The max bed temperature of 60°C is below the recommended 70°C for Nylon. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 240-280°C |
| Printer Max Nozzle | 260°C |
| Filament Bed Requirement | 70-90°C |
| Printer Max Bed | 60°C |
Was du stattdessen tun kannst
- Your printer's bed maxes out at 60°C, but Nylon needs at least 70°C for reliable adhesion.
- Try a compatible filament for your Monoprice MP Voxel — PLA, PETG, and ABS are good options.
- If you need Nylon specifically, you'll need a printer with a hotend capable of 240°C+ nozzle.
Nylon Requirements
Nylon Properties
| Nozzle Range | 240-280°C |
| Bed Range | 70-90°C |
| Speed Range | 30-50 mm/s |
| Difficulty | advanced |
| Enclosure | Required |
| Drying | 80°C / 16h |
Monoprice MP Voxel Specs
| Build Volume | 150 x 150 x 150 mm |
| Max Speed | 100 mm/s |
| Max Nozzle Temp | 260°C |
| Max Bed Temp | 60°C |
| Extruder | Direct Drive |
Nylon auf einen Blick
Stärken
- Highest tensile strength among common filaments (50-90 MPa)
- Excellent wear and abrasion resistance
- Excellent fatigue resistance (living hinges, snap fits)
- Good heat resistance (PA6 softens ~180C)
- Ideal for gears, bearings, and mechanical parts
Schwächen
- Extremely hygroscopic (absorbs moisture rapidly)
- Requires extensive drying (12-20 hours)
- Must print from a dry box
- Warps aggressively without enclosure
- Difficult to get right for beginners
Möchtest du personalisierte KI-Einstellungen?
Beschreibe dein genaues Setup und was du druckst. 3DSearch's KI-Experte erzeugt in Sekunden individuelle Slicer-Einstellungen für deinen Monoprice MP Voxel mit Nylon.
3DSearch ausprobieren →Quellen: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Werte berechnet aus Filament-Spezifikationen und Drucker-Hardware-Limits.