CPE Settings for Markforged Mark Two
Recommended slicer settings for printing CPE on the Markforged Mark Two (320 x 132 x 154 mm build volume, 200 mm/s max speed, direct drive extruder).
Nicht kompatibelintermediate
Nicht kompatibel
The max bed temperature of 0°C is below the recommended 75°C for CPE. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 240-270°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 75-90°C |
| Printer Max Bed | N/A |
Was du stattdessen tun kannst
- Your printer's bed maxes out at 0°C, but CPE needs at least 75°C for reliable adhesion.
- Try a compatible filament for your Markforged Mark Two — PLA, PETG, and ABS are good options.
- If you need CPE specifically, you'll need a printer with a hotend capable of 240°C+ nozzle.
CPE Requirements
CPE Properties
| Nozzle Range | 240-270°C |
| Bed Range | 75-90°C |
| Speed Range | 30-50 mm/s |
| Difficulty | intermediate |
| Enclosure | Not needed |
| Drying | 60°C / 6h |
Markforged Mark Two Specs
| Build Volume | 320 x 132 x 154 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
CPE auf einen Blick
Stärken
- Excellent chemical resistance
- Higher heat resistance than PETG (~100°C)
- Good toughness and impact resistance
- FDA-compliant grades available
Schwächen
- More difficult to print than PETG
- Higher temperatures required
- More prone to stringing
- Limited brand availability
Möchtest du personalisierte KI-Einstellungen?
Beschreibe dein genaues Setup und was du druckst. 3DSearch's KI-Experte erzeugt in Sekunden individuelle Slicer-Einstellungen für deinen Markforged Mark Two mit CPE.
3DSearch ausprobieren →Quellen: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Werte berechnet aus Filament-Spezifikationen und Drucker-Hardware-Limits.