PETG Settings for Monoprice MP Voxel
Recommended slicer settings for printing PETG on the Monoprice MP Voxel (150 x 150 x 150 mm build volume, 100 mm/s max speed, direct drive extruder).
غير متوافقbeginner
غير متوافق
The max bed temperature of 60°C is below the recommended 80°C for PETG. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 230-250°C |
| Printer Max Nozzle | 260°C |
| Filament Bed Requirement | 80-90°C |
| Printer Max Bed | 60°C |
ما الذي يجب فعله بدلاً من ذلك
- Your printer's bed maxes out at 60°C, but PETG needs at least 80°C for reliable adhesion.
- Try a compatible filament for your Monoprice MP Voxel — PLA, PETG, and ABS are good options.
- If you need PETG specifically, you'll need a printer with a hotend capable of 230°C+ nozzle.
PETG Requirements
PETG Properties
| Nozzle Range | 230-250°C |
| Bed Range | 80-90°C |
| Speed Range | 40-60 mm/s |
| Difficulty | beginner |
| Enclosure | Not needed |
| Drying | 65°C / 7h |
Monoprice MP Voxel Specs
| Build Volume | 150 x 150 x 150 mm |
| Max Speed | 100 mm/s |
| Max Nozzle Temp | 260°C |
| Max Bed Temp | 60°C |
| Extruder | Direct Drive |
PETG في لمحة
نقاط القوة
- Excellent all-around material for functional parts
- Good impact resistance (much better than PLA)
- Moderate heat resistance (softens ~80C)
- FDA-approved for food contact in raw form
- Good chemical resistance
- Semi-flexible (bends before breaking)
نقاط الضعف
- Prone to stringing
- Moderate moisture sensitivity
- Can bond too strongly to glass beds
- Lower fan speeds required (not great for overhangs)
تريد إعدادات AI مخصصة؟
صِف إعدادك الدقيق وما تطبعه. يُنشئ خبير AI في 3DSearch إعدادات تقطيع مخصصة لطابعتك Monoprice MP Voxel مع PETG خلال ثوانٍ.
جرّب 3DSearch →المصادر: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. تم حساب القيم من مواصفات الفيلامنت وحدود عتاد الطابعة.