PEI / ULTEM Settings for Markforged Mark Two
Recommended slicer settings for printing PEI / ULTEM on the Markforged Mark Two (320 x 132 x 154 mm build volume, 200 mm/s max speed, direct drive extruder).
غير متوافق
The Markforged Mark Two has a max nozzle temperature of 300°C, which may be below the minimum recommended 350°C for PEI / ULTEM. Printing may be possible at the lower end of the temperature range but results may be suboptimal. The max bed temperature of 0°C is below the recommended 130°C for PEI / ULTEM. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 350-400°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 130-160°C |
| Printer Max Bed | N/A |
ما الذي يجب فعله بدلاً من ذلك
- Your printer's hotend maxes out at 300°C, but PEI / ULTEM needs at least 350°C. No amount of tuning can overcome this hardware limitation.
- Your printer's bed maxes out at 0°C, but PEI / ULTEM needs at least 130°C for reliable adhesion.
- Try a compatible filament for your Markforged Mark Two — PLA, PETG, and ABS are good options.
- If you need PEI / ULTEM specifically, you'll need a printer with an all-metal hotend rated for 350°C+ nozzle and 130°C+ heated bed.
PEI / ULTEM Requirements
PEI / ULTEM Properties
| Nozzle Range | 350-400°C |
| Bed Range | 130-160°C |
| Speed Range | 15-30 mm/s |
| Difficulty | advanced |
| Enclosure | Required |
| Drying | 150°C / 8h |
Markforged Mark Two Specs
| Build Volume | 320 x 132 x 154 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
PEI / ULTEM في لمحة
نقاط القوة
- Flame retardant — self-extinguishing
- Excellent heat resistance (200°C+ continuous)
- Used in aerospace and automotive
- Good chemical resistance
نقاط الضعف
- Requires specialized industrial printer
- Very expensive (~$200-500/kg)
- Needs heated enclosure at 120°C+
- Extremely limited availability
تريد إعدادات AI مخصصة؟
صِف إعدادك الدقيق وما تطبعه. يُنشئ خبير AI في 3DSearch إعدادات تقطيع مخصصة لطابعتك Markforged Mark Two مع PEI / ULTEM خلال ثوانٍ.
جرّب 3DSearch →المصادر: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. تم حساب القيم من مواصفات الفيلامنت وحدود عتاد الطابعة.