HIPS Settings for Snapmaker 2.0 A350T
Recommended slicer settings for printing HIPS on the Snapmaker 2.0 A350T (320 x 350 x 330 mm build volume, 200 mm/s max speed, direct drive extruder).
Uyumlu Değilintermediate
Uyumlu Değil
The max bed temperature of 80°C is below the recommended 90°C for HIPS. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 230-245°C |
| Printer Max Nozzle | 275°C |
| Filament Bed Requirement | 90-110°C |
| Printer Max Bed | 80°C |
Bunun yerine yapılması gerekenler
- Your printer's bed maxes out at 80°C, but HIPS needs at least 90°C for reliable adhesion.
- Try a compatible filament for your Snapmaker 2.0 A350T — PLA, PETG, and ABS are good options.
- If you need HIPS specifically, you'll need a printer with a hotend capable of 230°C+ nozzle.
HIPS Requirements
HIPS Properties
| Nozzle Range | 230-245°C |
| Bed Range | 90-110°C |
| Speed Range | 40-50 mm/s |
| Difficulty | intermediate |
| Enclosure | Required |
| Drying | Not required |
Snapmaker 2.0 A350T Specs
| Build Volume | 320 x 350 x 330 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 275°C |
| Max Bed Temp | 80°C |
| Extruder | Direct Drive |
HIPS Bir Bakışta
Güçlü Yönleri
- Dissolves in D-Limonene (support material for ABS)
- Much cheaper than PVA ($20-25/kg)
- Low moisture sensitivity
- Can be used as standalone lightweight material
- Easy to paint and post-process
Zayıf Yönleri
- Requires D-Limonene solvent
- Only pairs well with ABS
- Needs enclosure (same as ABS)
- Less common than PVA for support use
Kişiselleştirilmiş yapay zeka ayarları ister misin?
Tam kurulumunu ve ne yazdırdığını açıkla. 3DSearch'ün yapay zeka uzmanı saniyeler içinde HIPS ile Snapmaker 2.0 A350T için özel slicer ayarları oluşturuyor.
3DSearch'ü dene →Kaynaklar: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Değerler filament belirtimleri ve yazıcı donanım sınırlarından hesaplanmıştır.