BVOH Settings for Markforged FX20
Recommended slicer settings for printing BVOH on the Markforged FX20 (525 x 400 x 400 mm build volume, 250 mm/s max speed, direct drive extruder).
Uyumlu Değilbeginner
Uyumlu Değil
The max bed temperature of 0°C is below the recommended 50°C for BVOH. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 190-220°C |
| Printer Max Nozzle | 385°C |
| Filament Bed Requirement | 50-60°C |
| Printer Max Bed | N/A |
Bunun yerine yapılması gerekenler
- Your printer's bed maxes out at 0°C, but BVOH needs at least 50°C for reliable adhesion.
- Try a compatible filament for your Markforged FX20 — PLA, PETG, and ABS are good options.
- If you need BVOH specifically, you'll need a printer with a hotend capable of 190°C+ nozzle.
BVOH Requirements
BVOH Properties
| Nozzle Range | 190-220°C |
| Bed Range | 50-60°C |
| Speed Range | 20-40 mm/s |
| Difficulty | beginner |
| Enclosure | Not needed |
| Drying | Not required |
Markforged FX20 Specs
| Build Volume | 525 x 400 x 400 mm |
| Max Speed | 250 mm/s |
| Max Nozzle Temp | 385°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
BVOH Bir Bakışta
Güçlü Yönleri
- Water-soluble support material
- Dissolves faster than PVA (2-4 hours)
- Works with wider range of build materials
- Leaves very clean supported surfaces
Zayıf Yönleri
- Extremely moisture sensitive — use immediately after opening
- More expensive than PVA
- Must store in sealed dry container
- Limited shelf life once opened
Kişiselleştirilmiş yapay zeka ayarları ister misin?
Tam kurulumunu ve ne yazdırdığını açıkla. 3DSearch'ün yapay zeka uzmanı saniyeler içinde BVOH ile Markforged FX20 için özel slicer ayarları oluşturuyor.
3DSearch'ü dene →Kaynaklar: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Değerler filament belirtimleri ve yazıcı donanım sınırlarından hesaplanmıştır.