PEI / ULTEM Settings for Anycubic Kobra 2 Pro
Recommended slicer settings for printing PEI / ULTEM on the Anycubic Kobra 2 Pro (220 x 220 x 250 mm build volume, 500 mm/s max speed, direct drive extruder).
Non compatible
The Anycubic Kobra 2 Pro has a max nozzle temperature of 260°C, which may be below the minimum recommended 350°C for PEI / ULTEM. Printing may be possible at the lower end of the temperature range but results may be suboptimal. The max bed temperature of 110°C is below the recommended 130°C for PEI / ULTEM. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 350-400°C |
| Printer Max Nozzle | 260°C |
| Filament Bed Requirement | 130-160°C |
| Printer Max Bed | 110°C |
Que faire à la place
- Your printer's hotend maxes out at 260°C, but PEI / ULTEM needs at least 350°C. No amount of tuning can overcome this hardware limitation.
- Your printer's bed maxes out at 110°C, but PEI / ULTEM needs at least 130°C for reliable adhesion.
- Try a compatible filament for your Anycubic Kobra 2 Pro — PLA, PETG, and ABS are good options.
- If you need PEI / ULTEM specifically, you'll need a printer with an all-metal hotend rated for 350°C+ nozzle and 130°C+ heated bed.
PEI / ULTEM Requirements
PEI / ULTEM Properties
| Nozzle Range | 350-400°C |
| Bed Range | 130-160°C |
| Speed Range | 15-30 mm/s |
| Difficulty | advanced |
| Enclosure | Required |
| Drying | 150°C / 8h |
Anycubic Kobra 2 Pro Specs
| Build Volume | 220 x 220 x 250 mm |
| Max Speed | 500 mm/s |
| Max Nozzle Temp | 260°C |
| Max Bed Temp | 110°C |
| Extruder | Direct Drive |
PEI / ULTEM en un coup d'œil
Points forts
- Flame retardant — self-extinguishing
- Excellent heat resistance (200°C+ continuous)
- Used in aerospace and automotive
- Good chemical resistance
Points faibles
- Requires specialized industrial printer
- Very expensive (~$200-500/kg)
- Needs heated enclosure at 120°C+
- Extremely limited availability
Tu veux des réglages IA personnalisés ?
Décris ton setup exact et ce que tu imprimes. L'expert IA de 3DSearch génère des réglages de slicer sur mesure pour ton Anycubic Kobra 2 Pro avec PEI / ULTEM en quelques secondes.
Essayer 3DSearch →Sources : Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Valeurs calculées à partir des spécifications du filament et des limites matérielles de l'imprimante.