PEI / ULTEM Settings for Anycubic Kobra 2 Max
Recommended slicer settings for printing PEI / ULTEM on the Anycubic Kobra 2 Max (420 x 420 x 500 mm build volume, 300 mm/s max speed, direct drive extruder).
Niet compatibel
The Anycubic Kobra 2 Max has a max nozzle temperature of 260°C, which may be below the minimum recommended 350°C for PEI / ULTEM. Printing may be possible at the lower end of the temperature range but results may be suboptimal. The max bed temperature of 90°C is below the recommended 130°C for PEI / ULTEM. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 350-400°C |
| Printer Max Nozzle | 260°C |
| Filament Bed Requirement | 130-160°C |
| Printer Max Bed | 90°C |
Wat je in plaats daarvan kunt doen
- Your printer's hotend maxes out at 260°C, but PEI / ULTEM needs at least 350°C. No amount of tuning can overcome this hardware limitation.
- Your printer's bed maxes out at 90°C, but PEI / ULTEM needs at least 130°C for reliable adhesion.
- Try a compatible filament for your Anycubic Kobra 2 Max — PLA, PETG, and ABS are good options.
- If you need PEI / ULTEM specifically, you'll need a printer with an all-metal hotend rated for 350°C+ nozzle and 130°C+ heated bed.
PEI / ULTEM Requirements
PEI / ULTEM Properties
| Nozzle Range | 350-400°C |
| Bed Range | 130-160°C |
| Speed Range | 15-30 mm/s |
| Difficulty | advanced |
| Enclosure | Required |
| Drying | 150°C / 8h |
Anycubic Kobra 2 Max Specs
| Build Volume | 420 x 420 x 500 mm |
| Max Speed | 300 mm/s |
| Max Nozzle Temp | 260°C |
| Max Bed Temp | 90°C |
| Extruder | Direct Drive |
PEI / ULTEM in één oogopslag
Sterke punten
- Flame retardant — self-extinguishing
- Excellent heat resistance (200°C+ continuous)
- Used in aerospace and automotive
- Good chemical resistance
Zwakke punten
- Requires specialized industrial printer
- Very expensive (~$200-500/kg)
- Needs heated enclosure at 120°C+
- Extremely limited availability
Wil je gepersonaliseerde AI-instellingen?
Beschrijf je exacte setup en wat je afdrukt. 3DSearch's AI-expert genereert in seconden aangepaste slicer-instellingen voor je Anycubic Kobra 2 Max met PEI / ULTEM.
Probeer 3DSearch →Bronnen: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Waarden berekend op basis van filamentspecificaties en printerhard warelimiet.