PP Settings for Snapmaker 2.0 A350T
Recommended slicer settings for printing PP on the Snapmaker 2.0 A350T (320 x 350 x 330 mm build volume, 200 mm/s max speed, direct drive extruder).
Несовместимоadvanced
Несовместимо
The max bed temperature of 80°C is below the recommended 85°C for PP. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 220-250°C |
| Printer Max Nozzle | 275°C |
| Filament Bed Requirement | 85-100°C |
| Printer Max Bed | 80°C |
Что делать вместо этого
- Your printer's bed maxes out at 80°C, but PP needs at least 85°C for reliable adhesion.
- Try a compatible filament for your Snapmaker 2.0 A350T — PLA, PETG, and ABS are good options.
- If you need PP specifically, you'll need a printer with a hotend capable of 220°C+ nozzle.
PP Requirements
PP Properties
| Nozzle Range | 220-250°C |
| Bed Range | 85-100°C |
| Speed Range | 20-40 mm/s |
| Difficulty | advanced |
| Enclosure | Not needed |
| Drying | 55°C / 6h |
Snapmaker 2.0 A350T Specs
| Build Volume | 320 x 350 x 330 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 275°C |
| Max Bed Temp | 80°C |
| Extruder | Direct Drive |
PP с первого взгляда
Сильные стороны
- Chemically inert — resists most solvents and acids
- Flexible living hinges
- Fatigue resistant — can be bent repeatedly
- Food-safe and lightweight
Слабые стороны
- Terrible bed adhesion — needs PP tape or packing tape
- Warps severely
- Very difficult to bond or glue
- Limited color availability
Хочешь персонализированные параметры ИИ?
Опиши свою точную конфигурацию и то, что ты печатаешь. Эксперт ИИ 3DSearch генерирует пользовательские параметры слайсера для твоего Snapmaker 2.0 A350T с PP за секунды.
Попробуй 3DSearch →Источники: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Значения рассчитаны на основе спецификаций филамента и ограничений аппаратного обеспечения принтера.