TPC Settings for Markforged FX20
Recommended slicer settings for printing TPC on the Markforged FX20 (525 x 400 x 400 mm build volume, 250 mm/s max speed, direct drive extruder).
Niet compatibelintermediate
Niet compatibel
The max bed temperature of 0°C is below the recommended 40°C for TPC. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 210-240°C |
| Printer Max Nozzle | 385°C |
| Filament Bed Requirement | 40-60°C |
| Printer Max Bed | N/A |
Wat je in plaats daarvan kunt doen
- Your printer's bed maxes out at 0°C, but TPC needs at least 40°C for reliable adhesion.
- Try a compatible filament for your Markforged FX20 — PLA, PETG, and ABS are good options.
- If you need TPC specifically, you'll need a printer with a hotend capable of 210°C+ nozzle.
TPC Requirements
TPC Properties
| Nozzle Range | 210-240°C |
| Bed Range | 40-60°C |
| Speed Range | 15-30 mm/s |
| Difficulty | intermediate |
| Enclosure | Not needed |
| Drying | 50°C / 5h |
Markforged FX20 Specs
| Build Volume | 525 x 400 x 400 mm |
| Max Speed | 250 mm/s |
| Max Nozzle Temp | 385°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
TPC in één oogopslag
Sterke punten
- Flexible co-polyester — better chemical resistance than TPU
- Good UV resistance for outdoor flexible parts
- Better printability than TPE
- Good temperature resistance
Zwakke punten
- Less flexible than TPU at same hardness
- More expensive than TPU
- Limited brand availability
- Fewer color options
Wil je gepersonaliseerde AI-instellingen?
Beschrijf je exacte setup en wat je afdrukt. 3DSearch's AI-expert genereert in seconden aangepaste slicer-instellingen voor je Markforged FX20 met TPC.
Probeer 3DSearch →Bronnen: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Waarden berekend op basis van filamentspecificaties en printerhard warelimiet.