PA6 Settings for Markforged FX20
Recommended slicer settings for printing PA6 on the Markforged FX20 (525 x 400 x 400 mm build volume, 250 mm/s max speed, direct drive extruder).
Niet compatibeladvanced
Niet compatibel
The max bed temperature of 0°C is below the recommended 80°C for PA6. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 240-270°C |
| Printer Max Nozzle | 385°C |
| Filament Bed Requirement | 80-100°C |
| Printer Max Bed | N/A |
Wat je in plaats daarvan kunt doen
- Your printer's bed maxes out at 0°C, but PA6 needs at least 80°C for reliable adhesion.
- Try a compatible filament for your Markforged FX20 — PLA, PETG, and ABS are good options.
- If you need PA6 specifically, you'll need a printer with a hotend capable of 240°C+ nozzle.
PA6 Requirements
PA6 Properties
| Nozzle Range | 240-270°C |
| Bed Range | 80-100°C |
| Speed Range | 30-50 mm/s |
| Difficulty | advanced |
| Enclosure | Required |
| Drying | 85°C / 12h |
Markforged FX20 Specs
| Build Volume | 525 x 400 x 400 mm |
| Max Speed | 250 mm/s |
| Max Nozzle Temp | 385°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
PA6 in één oogopslag
Sterke punten
- Strongest common nylon variant
- Exceptional wear and fatigue resistance
- Good chemical resistance
- Excellent for gears, bearings, hinges
Zwakke punten
- Extremely hygroscopic — must dry extensively
- Warps aggressively without enclosure
- Difficult bed adhesion
- Shrinks significantly during cooling
Wil je gepersonaliseerde AI-instellingen?
Beschrijf je exacte setup en wat je afdrukt. 3DSearch's AI-expert genereert in seconden aangepaste slicer-instellingen voor je Markforged FX20 met PA6.
Probeer 3DSearch →Bronnen: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Waarden berekend op basis van filamentspecificaties en printerhard warelimiet.