PLA+ Settings for Markforged FX20
Recommended slicer settings for printing PLA+ on the Markforged FX20 (525 x 400 x 400 mm build volume, 250 mm/s max speed, direct drive extruder).
Nicht kompatibelbeginner
Nicht kompatibel
The max bed temperature of 0°C is below the recommended 50°C for PLA+. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 200-230°C |
| Printer Max Nozzle | 385°C |
| Filament Bed Requirement | 50-70°C |
| Printer Max Bed | N/A |
Was du stattdessen tun kannst
- Your printer's bed maxes out at 0°C, but PLA+ needs at least 50°C for reliable adhesion.
- Try a compatible filament for your Markforged FX20 — PLA, PETG, and ABS are good options.
- If you need PLA+ specifically, you'll need a printer with a hotend capable of 200°C+ nozzle.
PLA+ Requirements
PLA+ Properties
| Nozzle Range | 200-230°C |
| Bed Range | 50-70°C |
| Speed Range | 40-60 mm/s |
| Difficulty | beginner |
| Enclosure | Not needed |
| Drying | Not required |
Markforged FX20 Specs
| Build Volume | 525 x 400 x 400 mm |
| Max Speed | 250 mm/s |
| Max Nozzle Temp | 385°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
PLA+ auf einen Blick
Stärken
- Up to 4x better impact resistance than PLA
- Higher heat tolerance (70-80C vs 55-60C for PLA)
- Better layer adhesion
- Less brittle than standard PLA
- Same ease of printing as PLA
Schwächen
- Not a standardized spec (varies by brand)
- Slightly more expensive than PLA
- Some brands offer little improvement over regular PLA
- Still not suitable for high-heat or heavy-load applications
Möchtest du personalisierte KI-Einstellungen?
Beschreibe dein genaues Setup und was du druckst. 3DSearch's KI-Experte erzeugt in Sekunden individuelle Slicer-Einstellungen für deinen Markforged FX20 mit PLA+.
3DSearch ausprobieren →Quellen: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Werte berechnet aus Filament-Spezifikationen und Drucker-Hardware-Limits.