POM Settings for Anycubic Kobra 2 Max
Recommended slicer settings for printing POM on the Anycubic Kobra 2 Max (420 x 420 x 500 mm build volume, 300 mm/s max speed, direct drive extruder).
Nicht kompatibeladvanced
Nicht kompatibel
The max bed temperature of 90°C is below the recommended 100°C for POM. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 200-220°C |
| Printer Max Nozzle | 260°C |
| Filament Bed Requirement | 100-130°C |
| Printer Max Bed | 90°C |
Was du stattdessen tun kannst
- Your printer's bed maxes out at 90°C, but POM needs at least 100°C for reliable adhesion.
- Try a compatible filament for your Anycubic Kobra 2 Max — PLA, PETG, and ABS are good options.
- If you need POM specifically, you'll need a printer with a hotend capable of 200°C+ nozzle and 100°C+ heated bed.
POM Requirements
POM Properties
| Nozzle Range | 200-220°C |
| Bed Range | 100-130°C |
| Speed Range | 20-40 mm/s |
| Difficulty | advanced |
| Enclosure | Not needed |
| Drying | 60°C / 6h |
Anycubic Kobra 2 Max Specs
| Build Volume | 420 x 420 x 500 mm |
| Max Speed | 300 mm/s |
| Max Nozzle Temp | 260°C |
| Max Bed Temp | 90°C |
| Extruder | Direct Drive |
POM auf einen Blick
Stärken
- Lowest friction of any printable plastic
- Replaces machined Delrin/Acetal parts
- Self-lubricating — ideal for gears and bearings
- Excellent fatigue resistance
Schwächen
- Extremely difficult bed adhesion
- Requires POM-specific build surface or tape
- Emits formaldehyde fumes — ventilation required
- Very few printers handle it well
Möchtest du personalisierte KI-Einstellungen?
Beschreibe dein genaues Setup und was du druckst. 3DSearch's KI-Experte erzeugt in Sekunden individuelle Slicer-Einstellungen für deinen Anycubic Kobra 2 Max mit POM.
3DSearch ausprobieren →Quellen: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Werte berechnet aus Filament-Spezifikationen und Drucker-Hardware-Limits.