Glow-in-the-dark PLA Settings for Monoprice MP Select Mini

Temperature Settings

Start with the nozzle at 210°C and the bed at 55°C. If you see poor layer adhesion, increase the nozzle temperature by 5°C increments. If you experience stringing, decrease the nozzle temperature by 5°C. For the first layer, you can increase the bed temperature by 5°C for better adhesion, then let it drop back to 55°C for subsequent layers.

The Glow-in-the-dark PLA filament has a recommended nozzle temperature range of 195-225°C and a bed temperature range of 50-60°C. The Monoprice MP Select Mini supports nozzle temperatures up to 260°C and bed temperatures up to 60°C, which fully covers the recommended range for this filament.

Speed & Quality

For the Monoprice MP Select Mini, a print speed of 30-50 mm/s works well with Glow-in-the-dark PLA. The first layer should be printed at 15-25 mm/s for solid bed adhesion. Outer walls at 70-80% of the main speed produce cleaner surface finishes.

For quality-critical prints like miniatures or display pieces, reduce the speed to 30 mm/s and use a 0.12-0.16mm layer height. For draft or rapid prototyping, you can push the speed to 50 mm/s with a 0.24-0.28mm layer height. The standard 0.2mm layer height at 40 mm/s provides the best balance of speed and quality for most prints.

Bed Adhesion

PLA adheres well to PEI sheets (smooth or textured) without any adhesive. If using a glass bed, apply a thin layer of glue stick or hairspray. Clean the bed with isopropyl alcohol (IPA) before each print for consistent adhesion.

Common Issues with Glow-in-the-dark PLA on Monoprice MP Select Mini

Here are the most common problems you may encounter when printing Glow-in-the-dark PLA on the Monoprice MP Select Mini, along with proven solutions:

• Stringing: Lower nozzle temperature by 5°C and increase retraction distance slightly
• Warping (rare): Increase bed temperature to 60°C, use a brim, and clean the bed with IPA
• Poor layer adhesion: Increase nozzle temperature by 5°C and check if filament is wet
• Brittle prints: Filament may be old or moisture-damaged; try drying at 50°C for 4-5 hours

Tips for Best Results

Follow these expert tips to get the best possible prints with Glow-in-the-dark PLA on your Monoprice MP Select Mini:

• Print a temperature tower to find the sweet spot for your specific PLA brand
• Store filament in an airtight container with desiccant when not in use
• Clean the bed with IPA before every print for consistent adhesion
• Use 100% cooling fan from layer 2 onward for best overhangs and bridging
• PLA is great for prototyping but avoid leaving prints in hot cars or direct sunlight

Support Settings

For prints requiring supports with Glow-in-the-dark PLA, use tree supports for easier removal and less scarring. Set a 0.15-0.2mm Z-distance between support and model. If you have a dual-extruder setup, consider PVA (for PLA/PETG) or HIPS (for ABS) as dedicated water/solvent-soluble support material.

Glow-in-the-dark PLA at a Glance

Monoprice MP Select Mini Specifications

The Monoprice MP Select Mini features a 120 x 120 x 120 mm build volume with a maximum print speed of 55 mm/s. It uses a Bowden extruder system, which is lighter on the print head but may require additional tuning for flexible filaments like TPU. The hotend can reach 260°C and the heated bed supports temperatures up to 60°C.