PLA Settings for Markforged FX10
Recommended slicer settings for printing PLA on the Markforged FX10 (400 x 330 x 315 mm build volume, 250 mm/s max speed, direct drive extruder).
Not Compatiblebeginner
Not Compatible
The max bed temperature of 0°C is below the recommended 50°C for PLA. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 190-220°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 50-60°C |
| Printer Max Bed | N/A |
What to do instead
- Your printer's bed maxes out at 0°C, but PLA needs at least 50°C for reliable adhesion.
- Try a compatible filament for your Markforged FX10 — PLA, PETG, and ABS are good options.
- If you need PLA specifically, you'll need a printer with a hotend capable of 190°C+ nozzle.
PLA Requirements
PLA Properties
| Nozzle Range | 190-220°C |
| Bed Range | 50-60°C |
| Speed Range | 40-60 mm/s |
| Difficulty | beginner |
| Enclosure | Not needed |
| Drying | Not required |
Markforged FX10 Specs
| Build Volume | 400 x 330 x 315 mm |
| Max Speed | 250 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
PLA at a Glance
Strengths
- Easiest filament to print with
- No heated bed strictly required (helps though)
- Wide range of colors available
- Low warping
- Biodegradable (derived from corn starch)
- Good tensile strength (47-60 MPa)
Weaknesses
- Low heat resistance (softens at 55-60C)
- Brittle under impact
- Poor UV/outdoor resistance
- Not food-safe without coating
Want personalized AI settings?
Describe your exact setup and what you are printing. 3DSearch's AI expert generates custom slicer settings for your Markforged FX10 with PLA in seconds.
Try 3DSearch →Sources: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Values calculated from filament specifications and printer hardware limits.