TPU 95A Settings for Elegoo Centauri Carbon 2

Temperature Settings

Start with the nozzle at 223°C and the bed at 50°C. If you see poor layer adhesion, increase the nozzle temperature by 5°C increments. If you experience stringing, decrease the nozzle temperature by 5°C. For the first layer, you can increase the bed temperature by 5°C for better adhesion, then let it drop back to 50°C for subsequent layers.

The TPU 95A filament has a recommended nozzle temperature range of 210-235°C and a bed temperature range of 40-60°C. The Elegoo Centauri Carbon 2 supports nozzle temperatures up to 320°C and bed temperatures up to 110°C, which fully covers the recommended range for this filament.

Speed & Quality

The Elegoo Centauri Carbon 2 supports high-speed printing at up to 500 mm/s. For TPU 95A, we recommend 15-30 mm/s for general printing. Start with the lower end for quality-critical prints and increase for draft prints. Always print the first layer at 25-50% of your normal speed for better adhesion.

For quality-critical prints like miniatures or display pieces, reduce the speed to 15 mm/s and use a 0.12-0.16mm layer height. For draft or rapid prototyping, you can push the speed to 30 mm/s with a 0.24-0.28mm layer height. The standard 0.2mm layer height at 23 mm/s provides the best balance of speed and quality for most prints.

Bed Adhesion

PLA adheres well to PEI sheets (smooth or textured) without any adhesive. If using a glass bed, apply a thin layer of glue stick or hairspray. Clean the bed with isopropyl alcohol (IPA) before each print for consistent adhesion.

Common Issues with TPU 95A on Elegoo Centauri Carbon 2

Here are the most common problems you may encounter when printing TPU 95A on the Elegoo Centauri Carbon 2, along with proven solutions:

• Stringing: Lower nozzle temperature by 5°C and increase retraction distance slightly
• Warping (rare): Increase bed temperature to 60°C, use a brim, and clean the bed with IPA
• Poor layer adhesion: Increase nozzle temperature by 5°C and check if filament is wet
• Brittle prints: Filament may be old or moisture-damaged; try drying at 50°C for 4-5 hours

Tips for Best Results

Follow these expert tips to get the best possible prints with TPU 95A on your Elegoo Centauri Carbon 2:

• Print a temperature tower to find the sweet spot for your specific PLA brand
• Store filament in an airtight container with desiccant when not in use
• Clean the bed with IPA before every print for consistent adhesion
• Use 100% cooling fan from layer 2 onward for best overhangs and bridging
• PLA is great for prototyping but avoid leaving prints in hot cars or direct sunlight

Support Settings

For prints requiring supports with TPU 95A, use tree supports for easier removal and less scarring. Set a 0.15-0.2mm Z-distance between support and model. If you have a dual-extruder setup, consider PVA (for PLA/PETG) or HIPS (for ABS) as dedicated water/solvent-soluble support material.

TPU 95A at a Glance

Elegoo Centauri Carbon 2 Specifications

The Elegoo Centauri Carbon 2 features a 256 x 256 x 256 mm build volume with a maximum print speed of 500 mm/s. It uses a direct drive extruder system, which provides better control over flexible and specialty filaments. The hotend can reach 320°C and the heated bed supports temperatures up to 110°C.