PEI / ULTEM Settings for Creality CR-6 SE
Recommended slicer settings for printing PEI / ULTEM on the Creality CR-6 SE (235 x 235 x 250 mm build volume, 100 mm/s max speed, Bowden extruder).
Nicht kompatibel
The Creality CR-6 SE has a max nozzle temperature of 260°C, which may be below the minimum recommended 350°C for PEI / ULTEM. Printing may be possible at the lower end of the temperature range but results may be suboptimal. The max bed temperature of 110°C is below the recommended 130°C for PEI / ULTEM. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 350-400°C |
| Printer Max Nozzle | 260°C |
| Filament Bed Requirement | 130-160°C |
| Printer Max Bed | 110°C |
Was du stattdessen tun kannst
- Your printer's hotend maxes out at 260°C, but PEI / ULTEM needs at least 350°C. No amount of tuning can overcome this hardware limitation.
- Your printer's bed maxes out at 110°C, but PEI / ULTEM needs at least 130°C for reliable adhesion.
- Try a compatible filament for your Creality CR-6 SE — PLA, PETG, and ABS are good options.
- If you need PEI / ULTEM specifically, you'll need a printer with an all-metal hotend rated for 350°C+ nozzle and 130°C+ heated bed.
PEI / ULTEM Requirements
PEI / ULTEM Properties
| Nozzle Range | 350-400°C |
| Bed Range | 130-160°C |
| Speed Range | 15-30 mm/s |
| Difficulty | advanced |
| Enclosure | Required |
| Drying | 150°C / 8h |
Creality CR-6 SE Specs
| Build Volume | 235 x 235 x 250 mm |
| Max Speed | 100 mm/s |
| Max Nozzle Temp | 260°C |
| Max Bed Temp | 110°C |
| Extruder | Bowden |
PEI / ULTEM auf einen Blick
Stärken
- Flame retardant — self-extinguishing
- Excellent heat resistance (200°C+ continuous)
- Used in aerospace and automotive
- Good chemical resistance
Schwächen
- Requires specialized industrial printer
- Very expensive (~$200-500/kg)
- Needs heated enclosure at 120°C+
- Extremely limited availability
Möchtest du personalisierte KI-Einstellungen?
Beschreibe dein genaues Setup und was du druckst. 3DSearch's KI-Experte erzeugt in Sekunden individuelle Slicer-Einstellungen für deinen Creality CR-6 SE mit PEI / ULTEM.
3DSearch ausprobieren →Quellen: Based on Creality support documentation, community testing data, manufacturer recommended ranges. Werte berechnet aus Filament-Spezifikationen und Drucker-Hardware-Limits.