PVA Settings for Markforged Onyx Pro
Recommended slicer settings for printing PVA on the Markforged Onyx Pro (320 x 132 x 154 mm build volume, 200 mm/s max speed, direct drive extruder).
Несовместимоintermediate
Несовместимо
The max bed temperature of 0°C is below the recommended 50°C for PVA. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 185-215°C |
| Printer Max Nozzle | 280°C |
| Filament Bed Requirement | 50-60°C |
| Printer Max Bed | N/A |
Что делать вместо этого
- Your printer's bed maxes out at 0°C, but PVA needs at least 50°C for reliable adhesion.
- Try a compatible filament for your Markforged Onyx Pro — PLA, PETG, and ABS are good options.
- If you need PVA specifically, you'll need a printer with a hotend capable of 185°C+ nozzle.
PVA Requirements
PVA Properties
| Nozzle Range | 185-215°C |
| Bed Range | 50-60°C |
| Speed Range | 20-30 mm/s |
| Difficulty | intermediate |
| Enclosure | Not needed |
| Drying | 50°C / 5h |
Markforged Onyx Pro Specs
| Build Volume | 320 x 132 x 154 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 280°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
PVA с первого взгляда
Сильные стороны
- Water-soluble support material
- Leaves near-perfect supported surfaces
- Dissolves in tap water (2-12 hours)
- Best paired with PLA
- No manual support removal needed
Слабые стороны
- Extremely moisture sensitive (dissolves in water)
- Expensive (~$40-60/kg)
- Requires dual-extruder setup
- Must be stored in airtight container at all times
- Brittle when moisture-damaged
Хочешь персонализированные параметры ИИ?
Опиши свою точную конфигурацию и то, что ты печатаешь. Эксперт ИИ 3DSearch генерирует пользовательские параметры слайсера для твоего Markforged Onyx Pro с PVA за секунды.
Попробуй 3DSearch →Источники: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Значения рассчитаны на основе спецификаций филамента и ограничений аппаратного обеспечения принтера.