Kevlar-fill Nylon Settings for Markforged Onyx Pro
Recommended slicer settings for printing Kevlar-fill Nylon on the Markforged Onyx Pro (320 x 132 x 154 mm build volume, 200 mm/s max speed, direct drive extruder).
Несовместимоadvanced
Несовместимо
The max bed temperature of 0°C is below the recommended 85°C for Kevlar-fill Nylon. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 245-275°C |
| Printer Max Nozzle | 280°C |
| Filament Bed Requirement | 85-100°C |
| Printer Max Bed | N/A |
Что делать вместо этого
- Your printer's bed maxes out at 0°C, but Kevlar-fill Nylon needs at least 85°C for reliable adhesion.
- Try a compatible filament for your Markforged Onyx Pro — PLA, PETG, and ABS are good options.
- If you need Kevlar-fill Nylon specifically, you'll need a printer with a hotend capable of 245°C+ nozzle.
Kevlar-fill Nylon Requirements
Kevlar-fill Nylon Properties
| Nozzle Range | 245-275°C |
| Bed Range | 85-100°C |
| Speed Range | 25-45 mm/s |
| Difficulty | advanced |
| Enclosure | Required |
| Drying | 85°C / 12h |
Markforged Onyx Pro Specs
| Build Volume | 320 x 132 x 154 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 280°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
Kevlar-fill Nylon с первого взгляда
Сильные стороны
- Kevlar fibers add toughness without brittleness
- Better impact resistance than carbon fiber nylon
- Good abrasion resistance
- Lighter than carbon fiber composites
Слабые стороны
- Hardened nozzle required
- Very hygroscopic
- Expensive and limited availability
- Lower stiffness than carbon fiber variants
Хочешь персонализированные параметры ИИ?
Опиши свою точную конфигурацию и то, что ты печатаешь. Эксперт ИИ 3DSearch генерирует пользовательские параметры слайсера для твоего Markforged Onyx Pro с Kevlar-fill Nylon за секунды.
Попробуй 3DSearch →Источники: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Значения рассчитаны на основе спецификаций филамента и ограничений аппаратного обеспечения принтера.