Glow-in-the-dark PLA Settings for Markforged Onyx Pro
Recommended slicer settings for printing Glow-in-the-dark PLA on the Markforged Onyx Pro (320 x 132 x 154 mm build volume, 200 mm/s max speed, direct drive extruder).
Несовместимоbeginner
Несовместимо
The max bed temperature of 0°C is below the recommended 50°C for Glow-in-the-dark PLA. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 195-225°C |
| Printer Max Nozzle | 280°C |
| Filament Bed Requirement | 50-60°C |
| Printer Max Bed | N/A |
Что делать вместо этого
- Your printer's bed maxes out at 0°C, but Glow-in-the-dark PLA needs at least 50°C for reliable adhesion.
- Try a compatible filament for your Markforged Onyx Pro — PLA, PETG, and ABS are good options.
- If you need Glow-in-the-dark PLA specifically, you'll need a printer with a hotend capable of 195°C+ nozzle.
Glow-in-the-dark PLA Requirements
Glow-in-the-dark PLA Properties
| Nozzle Range | 195-225°C |
| Bed Range | 50-60°C |
| Speed Range | 30-50 mm/s |
| Difficulty | beginner |
| Enclosure | Not needed |
| Drying | Not required |
Markforged Onyx Pro Specs
| Build Volume | 320 x 132 x 154 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 280°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
Glow-in-the-dark PLA с первого взгляда
Сильные стороны
- Charges in light and glows in the dark
- Fun for decorative and safety items
- Prints like standard PLA
Слабые стороны
- Phosphorescent particles are abrasive — hardened nozzle required
- Limited to green/blue glow colors
- Glow fades over minutes without recharging
- Surface finish is slightly grainy
Хочешь персонализированные параметры ИИ?
Опиши свою точную конфигурацию и то, что ты печатаешь. Эксперт ИИ 3DSearch генерирует пользовательские параметры слайсера для твоего Markforged Onyx Pro с Glow-in-the-dark PLA за секунды.
Попробуй 3DSearch →Источники: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Значения рассчитаны на основе спецификаций филамента и ограничений аппаратного обеспечения принтера.