PP Settings for Markforged FX10
Recommended slicer settings for printing PP on the Markforged FX10 (400 x 330 x 315 mm build volume, 250 mm/s max speed, direct drive extruder).
Несовместимоadvanced
Несовместимо
The max bed temperature of 0°C is below the recommended 85°C for PP. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 220-250°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 85-100°C |
| Printer Max Bed | N/A |
Что делать вместо этого
- Your printer's bed maxes out at 0°C, but PP needs at least 85°C for reliable adhesion.
- Try a compatible filament for your Markforged FX10 — PLA, PETG, and ABS are good options.
- If you need PP specifically, you'll need a printer with a hotend capable of 220°C+ nozzle.
PP Requirements
PP Properties
| Nozzle Range | 220-250°C |
| Bed Range | 85-100°C |
| Speed Range | 20-40 mm/s |
| Difficulty | advanced |
| Enclosure | Not needed |
| Drying | 55°C / 6h |
Markforged FX10 Specs
| Build Volume | 400 x 330 x 315 mm |
| Max Speed | 250 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
PP с первого взгляда
Сильные стороны
- Chemically inert — resists most solvents and acids
- Flexible living hinges
- Fatigue resistant — can be bent repeatedly
- Food-safe and lightweight
Слабые стороны
- Terrible bed adhesion — needs PP tape or packing tape
- Warps severely
- Very difficult to bond or glue
- Limited color availability
Хочешь персонализированные параметры ИИ?
Опиши свою точную конфигурацию и то, что ты печатаешь. Эксперт ИИ 3DSearch генерирует пользовательские параметры слайсера для твоего Markforged FX10 с PP за секунды.
Попробуй 3DSearch →Источники: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Значения рассчитаны на основе спецификаций филамента и ограничений аппаратного обеспечения принтера.