TPE Settings for Markforged Onyx Pro
Recommended slicer settings for printing TPE on the Markforged Onyx Pro (320 x 132 x 154 mm build volume, 200 mm/s max speed, direct drive extruder).
Niet compatibeladvanced
Niet compatibel
The max bed temperature of 0°C is below the recommended 30°C for TPE. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 200-230°C |
| Printer Max Nozzle | 280°C |
| Filament Bed Requirement | 30-50°C |
| Printer Max Bed | N/A |
Wat je in plaats daarvan kunt doen
- Your printer's bed maxes out at 0°C, but TPE needs at least 30°C for reliable adhesion.
- Try a compatible filament for your Markforged Onyx Pro — PLA, PETG, and ABS are good options.
- If you need TPE specifically, you'll need a printer with a hotend capable of 200°C+ nozzle.
TPE Requirements
TPE Properties
| Nozzle Range | 200-230°C |
| Bed Range | 30-50°C |
| Speed Range | 10-25 mm/s |
| Difficulty | advanced |
| Enclosure | Not needed |
| Drying | 50°C / 5h |
Markforged Onyx Pro Specs
| Build Volume | 320 x 132 x 154 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 280°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
TPE in één oogopslag
Sterke punten
- Softer than TPU — very rubber-like
- Excellent elasticity and memory
- Good for very flexible parts
- Chemical resistant
Zwakke punten
- Extremely difficult to print
- Direct drive required — impossible on Bowden
- Very slow speeds only
- Poor detail resolution due to softness
Wil je gepersonaliseerde AI-instellingen?
Beschrijf je exacte setup en wat je afdrukt. 3DSearch's AI-expert genereert in seconden aangepaste slicer-instellingen voor je Markforged Onyx Pro met TPE.
Probeer 3DSearch →Bronnen: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Waarden berekend op basis van filamentspecificaties en printerhard warelimiet.