Breakaway Support Settings for Markforged Onyx Pro
Recommended slicer settings for printing Breakaway Support on the Markforged Onyx Pro (320 x 132 x 154 mm build volume, 200 mm/s max speed, direct drive extruder).
Niet compatibelbeginner
Niet compatibel
The max bed temperature of 0°C is below the recommended 50°C for Breakaway Support. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 210-240°C |
| Printer Max Nozzle | 280°C |
| Filament Bed Requirement | 50-70°C |
| Printer Max Bed | N/A |
Wat je in plaats daarvan kunt doen
- Your printer's bed maxes out at 0°C, but Breakaway Support needs at least 50°C for reliable adhesion.
- Try a compatible filament for your Markforged Onyx Pro — PLA, PETG, and ABS are good options.
- If you need Breakaway Support specifically, you'll need a printer with a hotend capable of 210°C+ nozzle.
Breakaway Support Requirements
Breakaway Support Properties
| Nozzle Range | 210-240°C |
| Bed Range | 50-70°C |
| Speed Range | 30-50 mm/s |
| Difficulty | beginner |
| Enclosure | Not needed |
| Drying | Not required |
Markforged Onyx Pro Specs
| Build Volume | 320 x 132 x 154 mm |
| Max Speed | 200 mm/s |
| Max Nozzle Temp | 280°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
Breakaway Support in één oogopslag
Sterke punten
- Snaps off cleanly without solvents
- Fast removal — no dissolving wait time
- Works with most build materials
- No special post-processing needed
Zwakke punten
- Leaves rougher surface than dissolved supports
- Requires accessible support geometry
- Not suitable for internal cavities
- May need pliers for tight areas
Wil je gepersonaliseerde AI-instellingen?
Beschrijf je exacte setup en wat je afdrukt. 3DSearch's AI-expert genereert in seconden aangepaste slicer-instellingen voor je Markforged Onyx Pro met Breakaway Support.
Probeer 3DSearch →Bronnen: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Waarden berekend op basis van filamentspecificaties en printerhard warelimiet.