PLA Settings for Markforged FX10
Recommended slicer settings for printing PLA on the Markforged FX10 (400 x 330 x 315 mm build volume, 250 mm/s max speed, direct drive extruder).
Niet compatibelbeginner
Niet compatibel
The max bed temperature of 0°C is below the recommended 50°C for PLA. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 190-220°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 50-60°C |
| Printer Max Bed | N/A |
Wat je in plaats daarvan kunt doen
- Your printer's bed maxes out at 0°C, but PLA needs at least 50°C for reliable adhesion.
- Try a compatible filament for your Markforged FX10 — PLA, PETG, and ABS are good options.
- If you need PLA specifically, you'll need a printer with a hotend capable of 190°C+ nozzle.
PLA Requirements
PLA Properties
| Nozzle Range | 190-220°C |
| Bed Range | 50-60°C |
| Speed Range | 40-60 mm/s |
| Difficulty | beginner |
| Enclosure | Not needed |
| Drying | Not required |
Markforged FX10 Specs
| Build Volume | 400 x 330 x 315 mm |
| Max Speed | 250 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
PLA in één oogopslag
Sterke punten
- Easiest filament to print with
- No heated bed strictly required (helps though)
- Wide range of colors available
- Low warping
- Biodegradable (derived from corn starch)
- Good tensile strength (47-60 MPa)
Zwakke punten
- Low heat resistance (softens at 55-60C)
- Brittle under impact
- Poor UV/outdoor resistance
- Not food-safe without coating
Wil je gepersonaliseerde AI-instellingen?
Beschrijf je exacte setup en wat je afdrukt. 3DSearch's AI-expert genereert in seconden aangepaste slicer-instellingen voor je Markforged FX10 met PLA.
Probeer 3DSearch →Bronnen: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Waarden berekend op basis van filamentspecificaties en printerhard warelimiet.