PC-ABS Settings for Markforged FX10
Recommended slicer settings for printing PC-ABS on the Markforged FX10 (400 x 330 x 315 mm build volume, 250 mm/s max speed, direct drive extruder).
Niet compatibeladvanced
Niet compatibel
The max bed temperature of 0°C is below the recommended 100°C for PC-ABS. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 250-280°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 100-115°C |
| Printer Max Bed | N/A |
Wat je in plaats daarvan kunt doen
- Your printer's bed maxes out at 0°C, but PC-ABS needs at least 100°C for reliable adhesion.
- Try a compatible filament for your Markforged FX10 — PLA, PETG, and ABS are good options.
- If you need PC-ABS specifically, you'll need a printer with a hotend capable of 250°C+ nozzle and 100°C+ heated bed.
PC-ABS Requirements
PC-ABS Properties
| Nozzle Range | 250-280°C |
| Bed Range | 100-115°C |
| Speed Range | 30-50 mm/s |
| Difficulty | advanced |
| Enclosure | Required |
| Drying | 80°C / 8h |
Markforged FX10 Specs
| Build Volume | 400 x 330 x 315 mm |
| Max Speed | 250 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
PC-ABS in één oogopslag
Sterke punten
- Combines PC toughness with ABS workability
- Excellent impact resistance
- Good heat resistance (~115°C)
- Can be acetone-smoothed like ABS
Zwakke punten
- Requires enclosed printer
- Emits fumes — ventilation needed
- Warps without proper enclosure temperature
- Needs all-metal hotend
Wil je gepersonaliseerde AI-instellingen?
Beschrijf je exacte setup en wat je afdrukt. 3DSearch's AI-expert genereert in seconden aangepaste slicer-instellingen voor je Markforged FX10 met PC-ABS.
Probeer 3DSearch →Bronnen: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Waarden berekend op basis van filamentspecificaties en printerhard warelimiet.