CPE Settings for Markforged FX10
Recommended slicer settings for printing CPE on the Markforged FX10 (400 x 330 x 315 mm build volume, 250 mm/s max speed, direct drive extruder).
Niet compatibelintermediate
Niet compatibel
The max bed temperature of 0°C is below the recommended 75°C for CPE. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 240-270°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 75-90°C |
| Printer Max Bed | N/A |
Wat je in plaats daarvan kunt doen
- Your printer's bed maxes out at 0°C, but CPE needs at least 75°C for reliable adhesion.
- Try a compatible filament for your Markforged FX10 — PLA, PETG, and ABS are good options.
- If you need CPE specifically, you'll need a printer with a hotend capable of 240°C+ nozzle.
CPE Requirements
CPE Properties
| Nozzle Range | 240-270°C |
| Bed Range | 75-90°C |
| Speed Range | 30-50 mm/s |
| Difficulty | intermediate |
| Enclosure | Not needed |
| Drying | 60°C / 6h |
Markforged FX10 Specs
| Build Volume | 400 x 330 x 315 mm |
| Max Speed | 250 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
CPE in één oogopslag
Sterke punten
- Excellent chemical resistance
- Higher heat resistance than PETG (~100°C)
- Good toughness and impact resistance
- FDA-compliant grades available
Zwakke punten
- More difficult to print than PETG
- Higher temperatures required
- More prone to stringing
- Limited brand availability
Wil je gepersonaliseerde AI-instellingen?
Beschrijf je exacte setup en wat je afdrukt. 3DSearch's AI-expert genereert in seconden aangepaste slicer-instellingen voor je Markforged FX10 met CPE.
Probeer 3DSearch →Bronnen: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Waarden berekend op basis van filamentspecificaties en printerhard warelimiet.