PEEK Settings for Anycubic Kobra 2 Pro
Recommended slicer settings for printing PEEK on the Anycubic Kobra 2 Pro (220 x 220 x 250 mm build volume, 500 mm/s max speed, direct drive extruder).
Niet compatibel
The Anycubic Kobra 2 Pro has a max nozzle temperature of 260°C, which may be below the minimum recommended 370°C for PEEK. Printing may be possible at the lower end of the temperature range but results may be suboptimal. The max bed temperature of 110°C is below the recommended 130°C for PEEK. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 370-420°C |
| Printer Max Nozzle | 260°C |
| Filament Bed Requirement | 130-160°C |
| Printer Max Bed | 110°C |
Wat je in plaats daarvan kunt doen
- Your printer's hotend maxes out at 260°C, but PEEK needs at least 370°C. No amount of tuning can overcome this hardware limitation.
- Your printer's bed maxes out at 110°C, but PEEK needs at least 130°C for reliable adhesion.
- Try a compatible filament for your Anycubic Kobra 2 Pro — PLA, PETG, and ABS are good options.
- If you need PEEK specifically, you'll need a printer with an all-metal hotend rated for 370°C+ nozzle and 130°C+ heated bed.
PEEK Requirements
PEEK Properties
| Nozzle Range | 370-420°C |
| Bed Range | 130-160°C |
| Speed Range | 15-30 mm/s |
| Difficulty | advanced |
| Enclosure | Required |
| Drying | 150°C / 6h |
Anycubic Kobra 2 Pro Specs
| Build Volume | 220 x 220 x 250 mm |
| Max Speed | 500 mm/s |
| Max Nozzle Temp | 260°C |
| Max Bed Temp | 110°C |
| Extruder | Direct Drive |
PEEK in één oogopslag
Sterke punten
- Heat resistance up to 250°C continuous
- Exceptional chemical resistance
- Aerospace and medical grade material
- Biocompatible grades available
Zwakke punten
- Requires specialized printer (400°C+ hotend, heated enclosure)
- Extremely expensive (~$300-700/kg)
- Needs heated chamber at 120°C+
- Cannot be printed on consumer-grade machines
Wil je gepersonaliseerde AI-instellingen?
Beschrijf je exacte setup en wat je afdrukt. 3DSearch's AI-expert genereert in seconden aangepaste slicer-instellingen voor je Anycubic Kobra 2 Pro met PEEK.
Probeer 3DSearch →Bronnen: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. Waarden berekend op basis van filamentspecificaties en printerhard warelimiet.