PETG Settings for Markforged FX10
Recommended slicer settings for printing PETG on the Markforged FX10 (400 x 330 x 315 mm build volume, 250 mm/s max speed, direct drive extruder).
לא תואםbeginner
לא תואם
The max bed temperature of 0°C is below the recommended 80°C for PETG. Adhesion may be poor without additional bed adhesion aids.
| Filament Nozzle Requirement | 230-250°C |
| Printer Max Nozzle | 300°C |
| Filament Bed Requirement | 80-90°C |
| Printer Max Bed | N/A |
מה לעשות במקום
- Your printer's bed maxes out at 0°C, but PETG needs at least 80°C for reliable adhesion.
- Try a compatible filament for your Markforged FX10 — PLA, PETG, and ABS are good options.
- If you need PETG specifically, you'll need a printer with a hotend capable of 230°C+ nozzle.
PETG Requirements
PETG Properties
| Nozzle Range | 230-250°C |
| Bed Range | 80-90°C |
| Speed Range | 40-60 mm/s |
| Difficulty | beginner |
| Enclosure | Not needed |
| Drying | 65°C / 7h |
Markforged FX10 Specs
| Build Volume | 400 x 330 x 315 mm |
| Max Speed | 250 mm/s |
| Max Nozzle Temp | 300°C |
| Max Bed Temp | N/A |
| Extruder | Direct Drive |
PETG במבט מהיר
יתרונות
- Excellent all-around material for functional parts
- Good impact resistance (much better than PLA)
- Moderate heat resistance (softens ~80C)
- FDA-approved for food contact in raw form
- Good chemical resistance
- Semi-flexible (bends before breaking)
חסרונות
- Prone to stringing
- Moderate moisture sensitivity
- Can bond too strongly to glass beds
- Lower fan speeds required (not great for overhangs)
רוצה הגדרות AI מותאמות אישית?
תאר את ההגדרה המדויקת שלך ואת מה שאתה מדפיס. מומחה ה-AI של 3DSearch מייצר הגדרות סלייסר מותאמות עבור ה-Markforged FX10 שלך עם PETG תוך שניות.
נסה את 3DSearch →מקורות: Based on manufacturer specifications and community recommendations, community testing data, manufacturer recommended ranges. הערכים חושבו ממפרטי הפילמנט וממגבלות החומרה של המדפסת.